Apollo Help Center logo
Apollo Help Center logo

All articles

Apollo Pro 2020 Rear Fender Removal/ReplacementUpdated 6 months ago

This guide will show you how to replace the Apollo Pro’s fender if it’s broken or defective.

You will need the following tools:

  • Phillips' head screwdriver

STEP 1: Locate the fender screws

The Pro’s fender is secured with four bolts on the rear swingarms of the scooter. Start by locating these bolts. The screw’s locations are indicated below.

Step1.jpg

STEP 2: Remove fender screws

Insert a Phillips’ head screwdriver into the leftmost and uppermost bolt. Turn counterclockwise to loosen. Remove screw and set aside. Repeat with the remaining 3 screws.

Step2.gif

STEP 3: Remove fender

Lift the fender outward and towards the back. The fender should come cleanly off the swingarms.

Step3.gif

STEP 4: Hold new fender in place

Align the screw holes in your replacement fender with those in the swingarms.

Step4.gif

STEP 5: Reinsert bolts and tighten

Reinsert the bolts into the screw holes, starting with the leftmost. Tighten with a Phillips’ head screwdriver by turning clockwise. Repeat with remaining 3 screws

Step5.gif

You’re done!

If you have any other questions feel free to reach out to our A-Team at [email protected]

Was this article helpful?
Yes
No